CREALITY CR-10S PRO AUTO LEVELING AND PRINT(OFFICIAL)

By IRIS_CREALITY3D | 19 November 2018 | 11 Comments
Nygil
May 24,2020 20:01
I have problem of bed leveling, initially the printer worked well. now I can hear one side of the motor creating Noise while moving in z direction. (no smooth movement is achieved & also cant print.
    0
Lou
May 04,2020 14:40
I received a CRS 10 pro at the end of April. It worked for about week and when I went to move the printer about 20 feet from it's current location, the bed leveling sensor stopped working. If I shut the printer off and turn it back on the bed sensor gives
    0
STEVEN A WARD
April 16,2020 23:57
My CR-10S Pro auto level is not working and my emails to your support staff are not getting any response. How can this be fixed? The light on the top of the Auto Level does not come on under any conditions and even manually adjusting it has no effect.
    1
Giovanni Leo
March 02,2020 06:59
Dear Sir I have a CR-10s Pro I change the sensor and install an wrong one PNP in place of NPN Than I change it back to the original sensor NPN but now I have problem that the z offset When auto level the z axis go up every time at the measure point
    0
oraham
November 10,2019 07:41
Some new updates would help as this new update is really bad I do not want to use tiny machine update I should not have to . You Creality should update the firmware to new one working and no problems please update new firmware to many problem with 1.70.1
    3
Shane Wagner
October 16,2019 00:43
After the printer centers and finds the bed with enough space between the nozzle and bed for the feeler gauge, I aux level each corner. I then try to utilize auto-level but print nozzle drives into the bed at position 1 of 16. The probe never lights up to
    0
Maurizio
August 25,2019 18:18
Good morning everyone, I ask for help, the printer crashes during the measurement of the plan, already at the first point. Firmware 1.70.1, today I printed a piece and did it all ok, I start a second print after about an hour and it crashed and pierced th
    0
ALVARO DE AGUIAR FILHO
June 10,2019 02:07
Hello, my name is Alvaro, My CR 10s is not working, everything looks normal but the print does not start, what do I do? I bought in Brazil, I do not have the contact of the seller anymore, how do I do?
    0
arley alfaro
April 03,2019 06:57
hola, tengo problemas con el eje z el cual perdio el origen
    0
Richard
March 12,2019 02:56
I have some bug whit my CR-10s Pro (Creatily_Marlin1.1.6_CR-10sPro_1121_V1.60.3) : - Some time, when I make an auto levelin mesures, the scan of the 16 zones is mecanicly do but the display stay indefitly at the position 1. I have to turn 'off' and 'o
    2
Marian
January 27,2019 17:11
I have a problem with resetting the table temperature in the CR-10s Pro printer. During printing, which takes 1:15 at about 34 minutes, the table temperature is reset, as I bring the table temperature back to 60 degrees it will be at the end of the printo
    -1
Leave a Reply
Your email address will not be published.Required fields are marked. *
Name *
Email *
Content
Verification code