Leading brand of 3D Printing Solution Provider | Creality 3D
You are here: Home > Makers Guide
News Category

Makers Guide

CR-10S PRO 1.70.1V Firmware Installation

CR-10SPRO 1.60.71 firmware version is based on 1.60.3 version, help to solve the issue below:

1 when setting the hotbed/ nozzle target temperature to 0 during slicing the model, and the filament detector sometimes is not working.
2. when Auto home, the auto-leveling can be done by control the "Z+, Z-" to adjust the distance between the nozzle and the hotbed, thus no need to adjust the sensor knob.
3. Economic is on or off will be shown on the processing page while your printing.
4. compare to the older version, the new version can help print with the size of 300*300*400
5. 1.60.3 version: before auto home, the z-axis did not lift up, which may scratch the platform.
   1.60.71 version: the Z-axis will lift up 5mm then execute auto home.

New Function:
1. The 16 points of the storage data/OFFSET will show up when power on the printer.
2. Only when you use auto leveling mode, no matter there's G29 in the g-code file or not, it will test the 16 points( before printing, after reach up to the temperature), then start printing. if it is in non-auto leveling mode, it will not have the 16 points test.

Now, Creality had updated the CR10S PRO 1.70.1 base on the 1.60.71 Version, and it is with thermal runaway protection,
you can click here to download: https://www.creality.com/cr-10s-pro-3d-printer-p00253p1.html


Here are the updated Functions Below:
1. 
The 25 points of the storage data/OFFSET will show up when power on the printer.
2. It will stop printing while printing the model and release the motor itself.
3.  Click the leveling mode, after 2 minutes when auto home,  it will release the electronic signals of the XY axis, and retain electronic signals of Z-axis, keep the Z auto home/Z+/Z- effectively.
4. Solve the problem of the spillover from the nozzle, which results in poor adhesion when the XY axis auto home during the processing of resume printing/pause/filament sensor.
5. No additional parameters are loaded for execution during printing, and the buffer is cleared after printing, without disturbing the operation of the print instruction.

Creality CR-10S PRO 1. 70.1V Firmware Flashed Method is the same as 1.60.71,  You can check the video below: